6.5 pushrods

[Tileman]

I am looking for new pushrods and came across these. Is there a certain way that you install these one end up and a certain end down? Do these sound ok? "It is tipped with one welded .375 diameter M-4 tungsten steel ball (copper flashed with hole) and one welded .375 diameter steel ball (with hole)." Thanks Cass

[HJacobson]

There is usually a faint white stripe near the end that goes up on the pushrods. Lacking that, the tungsten ball should be up.

Severe wear can occur at the pushrod to rocker arm interface if the pushrods are not installed correctly.